So I can´t for the love of someone get Can Bus communication to work..
Maybe someone could help me here.
Master is set to ID 0 with "multiple escs over can" enabled.
slave is set to ID 1 with "send status over can" enabled.
Still only the master is spinning up.
I have tried different can bus cables where only Can Low and High is connected. Also checked both cables with multimeter and all is good with the wires.
So far I tried it with 3 individual vesc´s.
2 with HW 4.12 and 1 with HW 4.10
My own conclusion is that Can bus is broken on one of the 4.12 vesc´s. But if the chip was broken, the vesc should not power on..
Any thoughts fellow makers?